Water-based silicate

Specifications: 5L

Scope of application:

Suitable for all kinds of natural and artificial stone bibulous rate is high, such as sandstone, granite, marble, etc

Product performance:

This type of products for water-based environmentally friendly products, suitable for all kinds of stone.Can effectively penetrate into the stone material interior, surface trace, don't change color, after processing of stone material has good air permeability, waterproof performance, antifouling performance, prevent the moss and mold growth and effectively prevent stone water spot, hua, spit yellow wait for all sorts of pathological changes occur, when in contact with food products after curing, no toxicity, not harmful to human body.

Method:

1. The stone material must be dry, the stone surface is clean, keep the place well ventilated.

2. The protective agent directly with brush or sponge coating on the stone surface, crisscross full besmear to brush, shall not be omitted, brush after should have a certain amount of stone material surface protective agent for its absorption.Protective agent can handle per liter stone 8 to 25 square meters (depending on the absorption rate and the surface of stone material).The absorption rate of very large stone can increase the dose.Protective agent can handle per liter stone 5-10 square meters (depending on the stone varieties and surface).

3. In case of absorb bad stone, 10 minutes after erasing redundant protective agent of stone material surface, otherwise, may be left in stone material surface spot (especially black marble and granite, it is recommended to use HY106 or HY108).

4. Under the protective agent of stone material, 6 hours after a protective effect.Natural curing a week after the protective effect is best, 8 hours can not contact with rain.

5. The protective agent can be used for six stone material surface protection, bonded fastness of stone and cement mortar had no obvious effect.Suggest the bottom and do HY605 again.

6.4 ℃ above construction.Summer construction should prevent stone floor excessive exposure, which leads to the surface temperature is too high (more than 50 ℃) otherwise, reagent rate rise caused by dry too fast, and prevents the coating permeability.

7. The original packing seal storage life two years, two years later after the test protective effect is the same, still can continue to use.

Special remind:

1. Water-based protective agent alkali resistance is poor, should not be used in high alkaline environment, high alkali cement used in wet stick installation may cause failure protection layer, water-based products are used in contact with the wet cement paste must be careful when using, it is recommended to use oily products.

2. Besmear too much, can produce white crystal on the surface.

Note:

1. The high acid environment conducive to the product curing (stone after acid cleanser, must be the residual acid neutralization with sodium carbonate solution to neutral, or make the maintenance and failure).

2. Suggest to unfamiliar stone do small sample test, for at least 24 hours for the response.

3. Any contact with harsh chemicals and cleaning, may affect its useful life.

4. According to the inflammable material storage.

5. Keep out reach of children.

Emergency disposal:

1. The eyes rinse immediately with plenty of water after 15 minutes, and please accept the treatment of eye doctor.

2. The suction gas, please immediately transferred to the fresh air, and treated by doctors.

3. Please accept the doctor diagnosed after eating.

4. When in contact with skin, wash immediately with water and soap, please.

Production date: see the bottle